Specifications

Operating Instructions

1. Inflation

Note: The product is preset to transport mode at the factory. Before first use, connect a charger (Type-C or DC port) to deactivate transport mode.

• Screw the air hose onto the air outlet. Select the appropriate nozzle for your equipment and connect it.

• Press the Power button to turn on. Press again to enter inflation mode.

• Press the Mode button to select Car, Motorcycle, Bicycle, Ball, or Custom mode.

• Use the +/- buttons to adjust the preset pressure. Press the Power button to start inflation.

• During inflation, press the Power button again to stop.

• When powered on and the hose is connected, the display shows the current pressure.

• Inflation stops automatically when the preset pressure is reached.

• Press and hold the Mode button for 3 seconds to switch between PSI / BAR / KPA.

Safety Tip: Always check the required pressure for the item being inflated to avoid over-inflation and bursting. The allowable pressure range for car, bicycle, and motorcycle tires is marked on the tire sidewall. Recommended car tire pressure is usually on the driver’s side door jamb. Inflation pressure varies with load. For detailed recommendations, refer to the equipment manual.

2. Emergency Light

Press and hold the Emergency Light button to turn on. Short-press to switch between white work light and red warning light. Press and hold again to turn off.

3. Charging

Connect the charging cable to the Type-C port. The display shows “IN” and real-time battery level. The percentage flashes during charging. When fully charged, it shows 100%.

4. Pressure Calibration

If the display shows a non-zero pressure when no hose is connected after power-on, calibrate as follows: Press and hold both “+/-” buttons until the pressure value resets to 0. Calibration is complete.

5. Battery Maintenance

The product contains a built-in lithium battery. If not used for a long time, fully charge it every 3 months.

Safety Warnings

1. Do not store or use the product in high-temperature, strong magnetic, or humid environments.

2. Improper use may damage the product or endanger personal and property safety.

3. Avoid strong physical impact, including hitting, throwing, stepping, or crushing.

4. We assume no liability for consequences or legal responsibilities caused by improper use in violation of the manual.

5. Disassembly by non-professionals is strictly prohibited.

6. Not for use by children. The unit generates noise above 70dB during operation. Keep a safe distance and use personal protection.

7. During prolonged continuous inflation, the main unit and hose may become hot. Allow to cool to room temperature before further use.

8. The built-in DC motor may generate sparks during operation. Do not use in flammable or explosive environments.

9. Use in a dry, clean environment. Sand and dust may cause damage. The product is not waterproof. Do not rinse with water.